2018-11-20
took couple hours to setup. Got a leak in the middle of night! Fortunately we caught that early - maybe about 1 gallon water flooded in the cabinet and on the floor from the storage tank. Part of the blame was I did not pay attention the connector ( two ways) going to storage tank was missing the sleeve and blue clip. I did not think the sleeve could be come off and assumed it might be a special kind connector for the tank route. Well, later I found the sleeve and blue clip left in the plastic bag that wrapped the the head unit. This was a big lesson to learn. The other minor thing was the connection to the UV housing - the flow direction and connecting location was different from the manual. The manual has the in-flow pass through a UV sensor flow switch first to the end of the UV tube (light bulb end as a head), and the output is at the head side. My pre-configured was that the in-flow goes to the head side and the output at the other end with flow switch reversed connected (flow direction in this case is reversed as to the manual). I figured out the UV housing did not have IN or Out directional requirement, so I left it as it was. Overall the system performs well as stated. I decided to go for PH+ for better taste but UV would be a good complement to sanitize water after passing through those pellets in alkalized tube.
