0 0 |
2019-06-30

Connect it to the ice maker and it's working perfectly fine.

0 0 |
2019-06-27

The system arrived post haste and was quite simple to install thanks to the excellent instructions and set up of push fittings. Lastly, I went against the recommendation in the product instructions and did not install the supplied faucet. Got one with antique wine finish to match my faucet.

Richard Shilton |
2019-06-15

Works well, didn't cost much for me to have installed, best thing we no longer buy bottled water!

JOSE GOMEZ |
2019-06-11

So happy we got this for our family knowing that we have safe and reliable drinking water.

Steven McCray |
2019-06-08

I would strongly recommend this product. It actually tastes really good.

Rafal Maleska |
2019-05-25

Great product. Love the beautuiful faucet the water is good tasting.

0 0 |
2019-05-24

Comes very well packaged and has everything you need for installation. This system works great.

Evan Kinne |
2019-05-20

I have had this installed for several months now and it works perfectly.

0 0 |
2019-05-18

Very solid filter housings, metal bracket is a thick enough gauge, fittings and valves feel good and solid. A quality system that will last for years.

John R Bender |
2019-05-03

The filters are good sized and work just fine. The water flow rate out the faucet is good enough. However, I was concerned because of all the wrapping of Teflon tape around the two white plastic connectors that screw into the plastic filter holder. They were massively pre-wrapped with Teflon tape by the company, which leads me to believe they know these two connections are prone to leaking. Both inlet and outlet connections leaked - where the fittings screw into the filter holder, not at the hose push-in side! I had to add Teflon thread paste to the Teflon tape covered threads to stop the connectors from weeping. Not a great design at this connection because water pressure forces water to migrate up the threads, which are plastic, so don't over-tighten them (although you must apply quite a bit of torque, which I did.) An o-ring design would offer a better seal. I hope they don't leak again. So far it's working.